Joie Gemm and Juva Manual De Instrucciones página 3

5. Press the ISOFIX release button on
either side of the base, then pull
out the ISOFIX connectors.
!
There are 9 adjustable
positions for ISOFIX. Press the
ISOFIX release button and
push the base back against the
vehicle seat until tight.
6. Line up the ISOFIX connectors
with the ISOFIX anchor points,
and then click both ISOFIX
connectors into the ISOFIX
anchor points.
7
!
Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX
anchor points. The colors of
the indicators on the both
ISOFIX connectors should be
completely green. -1
7
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
3
6
6
2
7
1
7. Please refer to step 2 in section
'a. Installation with 3-point-
belt'for adjustment of load leg.
The completely assembled base is
shown as
8
!
The ISOFIX connectors must
be attached and locked onto
1
the ISOFIX anchor points.
-1
8
!
The load leg must be installed
correctly with green indicator.
-2
8
8. Push the child restraint down
into the base
9
restraint is secure, the child
restraint latched indicator shows
green. If the child restraint is not
secure, the latched indicator
shows red. -1
10
!
Press the recline adjustment
button -2 and adjust the
10
child restraint to the proper
position. The recline angles
has 7 positions.
!
Please readjust the load leg
height properly when recline
adjustment is not too smooth.
!
Face your child restraint
toward the rear of the vehicle.
!
Pull up on the child restraint to
be sure it is securely latched
into the base.
8
1
9
, if the child
10
2
1
2
4