Festool SSU 200 EB Manual De Instrucciones página 27

and a clearly legible bevel indicator. The power
tool is equipped with a pull-out guide ruler that
can be placed on either side of the runner and
guarantees a straight, accurate cut. The guide
strip can be quickly tilted back 10°. Chain ten­
sion can be comfortably adjusted using a wheel
that is easily accessible from the main handle.
A suitably shaped port for routing away sawdust
keeps the power tool clear and can be attached
to a suction hose.
During cutting, the chain receives optimal lubri­
cation from the oil feed pump. Once turned on,
the motor runs smoothly up to maximum RPM,
thanks to an electronic control unit. The motor
is electronically protected. In the event of an
accidental overload, it switches off automatical­
ly. If overloaded for a longer period, it switches
to "cooling mode", during which the power tool
runs at a low cooling RPM, and once cooled, it
returns to the normal operating mode. When
the power tool is turned off, an electric brake
activates, which significantly shortens the pow­
er tool's run-down time. Depending on the us­
age, this run-down time may vary considerably.
3.2 Tool properties
The SSU 200 EB sword saw is designed for
transversal and shorter longitudinal cuts in
dense, solid wood and similar materials.
The power tool is operated by a person who
holds and guides it using designated handles;
the basic grip is by the front auxiliary handle
and the main handle. Holding the rear auxiliary
handle is only permitted if there is no danger of
kickback. Any other usage of this power tool is
considered improper.
The power tool is not designed for felling or
trimming trees or bushes!
This power tool must not be operated by people
under 16 years of age.
The user is liable for improper or non-in­
tended use.
4 Technical data
Sword saw
Power supply
Mains frequency
Power consumption
Movable supply line
Fuse
5
SSU 200 EB
220–240 V~
50–60 Hz
1600 W
H07RN-F
15–16 A current
protection
Sword saw
Speed preselection
Stabilising electronics
Electric safety brake
Starting current limiter
Automatic lubrication of
the guide strip
Chain sprocket rotation
depending on setting of
electronics
Max. chain speed
Mitre cut
Cutting depth [20 cm (8") guide strip]
At 0°
At 15°
At 30°
At 45°
At 60°
Oil reservoir capacity
Weight as per EPTA pro­
cedure 01:2014
Parts of the machine
[1-1] Safety lock
[1-2]
Handle
[1-3] Switch button
[1-4]
Offset parallel side fence
[1-5] Chain guard
[1-6] Clamping screw for parallel side
fence
[1-7] Guide table
[1-8]
Front additional hand grip
[1-9] Oil level indicator
[1-10] Oil reservoir cap
[1-11] Rotating chip ejector
[1-12] Chain tensioning wheel
[1-13] Oil feed wheel
[1-14] Setting for drawing cut
[1-15] Speed preselection
English
SSU 200 EB
o
o
o
o
o
2200–4600 rpm
10.6 m/s
0°–60°
200 mm
190 mm
170 mm
140 mm
100 mm
~ 240 ml
6.5 kg
27