Midland BTX2 PRO Manual De Instrucciones página 23

Boom Microphone
Place the section with the Velcro/adhesive strip between the padding and the rigid cover
of the helmet, so that the microphone is correctly positioned in front of your mouth and
that the white symbol is facing your mouth. This type of microphone is suited for Open
Faced and Flip Front helmets.
Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in front of your
mouth. This type of microphone is more suited for Full Faced helmets. The mini con-
nector on the microphone allows you choose the microphone that best suits the helmet
you are using.
www.midlandeurope.com
Description of the
Slide-in mounting kit
The Midland BTX2 PRO can be fixed onto the helmet, installing the slide-in mounting kit
in two different ways: By either using the plate with bi-adhesive strip, or the screw plate.
These methods allow you to safely "fix" the BTX2 PRO unit onto your helmet and to
remove it at any time in order to recharge or store it.
Plate with bi-adhesive strip
Step 1. Tighten with the two provided screws, the bi-hadesive plate and the slide-in
mounting kit. Step.2 Clean the application area on the helmet surface, remove the bi-a-
dhesive film and place the fixing plate on the left side of the helmet by keeping it contact
with the surface for a few seconds.
Screw Clamp
Step 1. Tighten the screw plate to the slide-in mounting kit with the two provided screws.
Step.2 Then, tighten more the two screws in order to firmly fix the clamp in place on the
left side of the helmet.
23