How To Listen To The Fm Radio; Wired Audio Input - Midland BTX2 PRO Manual De Instrucciones

was already used), you lose the possibility to pair the phone to the Midland BTX2 PRO
unit. You can overcome this limit by pairing the phone directly to the GPS and then the
GPS to the Midland BTX2 PRO unit. All the phone features are therefore managed by
the GPS itself.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button. If paired on
"Volume -" and the "Background" feature is activated, the PMR446 radio is always in
the background even when you talk on the intercom.
Pairing procedure
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on perma-
nently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red light will flash.
› Follow now the pairing procedure explained on the manual of the transceiver itself

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch to the "FM Radio"
mode in order to use it. Long press the middle button until you hear "FM radio" from the voice
announcement. Now all the three main buttons are dedicated to the FM Radio (See Table C).
Press short the Forward or the Backward button to seek the FM Radio station. When you
press long the Forward or the Backward button, you can scan up or down the 6 recorded
stations. A voice announcement will tell you the number of which memory you are entering.
To save the station you are listening to, press the Forward and Backward buttons together
for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for the
radio station you like to listen. The RDS system is OFF by default, if needed you can toggle
C-Radio FM mode
Mode
FM Radio
32
Forward button
Short press: seek station up
Long press: Scan recorded
on/off the RDS pressing together the "Volume +" and "Volume –" buttons for 3 sec when
the radio is on. A voice announcement will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about 7
sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will flash
three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland BTX2
PRO
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
To exit the "Setup" mode, double click the "Middle" button.
FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the intercom, you can
only open it using VOX feature (just talk) to the unit paired on the "Middle" button. To
manually activate the intercom you must switch to "Intercom" mode.

Wired audio input

Your Midland BTX2 PRO can be connected to a wired audio source, like an iPod (or any
other MP3 Player).
Listening to music
To listen to music from the wired input, connect the audio source using the optional AUX
cable. The volume buttons (Vol + and Vol -) can be used to adjust the volume of the wired
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
www.midlandeurope.com