Star Power AS01 Manual De Usuario página 11

06 Maintenance
B.Running Belt Off-Center Adjustment
While using the treadmill, the pressure on the running belt is not balanced because the acting force from the left and right
feet is not exactly the same while running, which could easily cause the running belt to become off centered. That' s a
normal deviation. It will return to the center automatically when nobody is using the treadmill. Otherwise, you may need
to bring the running belt back to the center.
Operate the treadmill without anyone on it, adjust the speed to level 6, and observe the
distance between the left and right side bars.
• If it is too close to the left side, use a hex Allen wrench to turn the left screw 1/4 of the cycle clockwise;
• If it is too close to the right side, use a hex Allen wrench to turn the right screw 1/4 of the cycle clockwise;
• If the belt is still not well centered, repeat the above adjustments until it comes back to the center.
• After adjusting the running belt to the center, set the speed to level 6 and observe if there' s any deviation of the running
belt from the center or any slipping of the running belt. If the deviation persists, repeat above steps to further adjust.
Warning!
Do not overtighten the rollers! It may cause permanent damage to the bearing!
17
06 Maintenance
Lubricant
The treadmill is lubricated before it leaves the plant, but frequent inspection of the lubrication status of the treadmill
helps keep the treadmill in its best condition. The treadmill must be lubricated after one year of use or 100 hours of
operation.
After using for 30 hours or 30 days, whichever comes first, while the treadmill is stationed, lift the running belt from one
side and reach out to the surface underneath the running belt to decide the lubrication status. You do not need to add
more lubricant if you can touch the lubricant. But if it' s dried up, follow the instructions below to refill the lubricant.
(Please only use non-petroleum based lubricant)
Follow the figure below to properly add the lubricant. Open the refilling cover on the left front side of the side bar, use
scissors or a utility knife to cut the lubricant bottle at the position shown in the figure below, and add the lubricant
according to the figure at the bottom. Insert the thin rod at the front end of the lubricant bottle into the filling port on the
running board and fill in the lubricant.
18