Star Power AS01 Manual De Usuario página 12

07 General Troubleshooting
Error codes displayed on the electronic panel and related troubleshooting solutions
Error Code Error Description
SAFE Safety lockswitch falls off
(1).Check for loose, disconnected or damaged communication cables.
Communication failure,
Er1
(2).Check or replace the electronic panel if needed.
the electronic panel
(3).Check or replace the controller if needed.
cannot receive signal
(1).Check whether the voltage of the power supply is at a normal level of AC 110V.
Er 3 Overvoltage
(2).Check or replace the controller.
(3).Check or replace the motor.
(1).Check for overload status.
(2).Check if any mechanical moving part is stuck.
(3).Check the level of film release agent. The lack of film release agent may increase
(4).Check the running board for severe wear.
Er 4 Overcurrent
(5).Check the running belt for severe wear.
(6).Check if any short circuit exists in the motor line.
(7).Check or replace the controller.
(8).Check or replace the motor.
19
Troubleshooting Solutions
the friction between the running belt and the running board, which causes
overcurrent.
07 General Troubleshooting
Error Code Error Description
(1).Check for overload.
(2).Check if any mechanical moving part is stuck.
(3).Check the level of film release agent. The lack of film release agent may increase the
friction between the running belt and the running board, which causes overcurrent.
Er 5
overload
(4).Check the running board for severe wear.
(5).Check the running belt for severe wear.
(6).Check if any short circuit exists in the motor line.
(7).Check or replace the controller.
(8).Check or replace the motor.
(1).Check for loose or disconnected lines for the motor.
Er 6 Motor is not connected
(2).Check or replace the controller.
(3).Assess the need to replace the controller.
Communication failure,
(1).Check for loose, disconnected or damaged communication cables.
the controller cannot
Er 7 (2).Check or replace the electronic panel.
receive signals
(3).Check or replace the controller.
(1).Check if the treadmill is subject to strong interfering signals.
Er 13 IGBT Short Circuit
(2).Check or replace the controller.
(1).Check if there is any foreign object at the output of the controller that causes a short
Er 14 Load Short Circuit circuit.
(2).Check or replace the motor.
Troubleshooting Solutions
20