Descargar Imprimir esta página

Homelite HOMCS01 Manual Del Operador página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
To avoid serious personal injury, make sure the switch
trigger is locked out in the off position when cleaning or
performing any maintenance.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing and head
protection. Failure to do so could result in objects being
thrown into your eyes resulting in possible serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Never use water or any liquids to clean or rinse off your
product and do not expose the product to rain or wet
conditions. Store indoors in a dry area. Corrosive liquids,
water, and chemicals can enter the product's electronic
components and/or battery compartment and damage
electronic components and/or the battery pack, which can
result in a short circuit, increased risk of fire, and serious
personal injury. Remove any buildup of dirt and debris by
wiping the product clean with a dry cloth occasionally.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
MAINTENANCE
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal injury.
REPLACING BAR AND CHAIN
See Figures 13 - 18.
WARNING:
Make sure the switch trigger is locked out in the off posi-
tion and the chain has stopped before you do any work on
the saw. Failure to do so may result in accidental starting
and possible serious injury.
WARNING:
To avoid serious personal injury, read and understand all
the safety instructions in this section.
WARNING:
Never touch or adjust the chain while the motor is running.
The saw chain is very sharp; always wear protective gloves
when performing maintenance to the chain to avoid pos-
sible serious lacerations.
CAUTION:
Always wear gloves when handling the bar and chain;
these components are sharp and may contain burrs.
 Make sure the switch trigger is locked out in the off
position.
 Rotate chain cover lock knob counterclockwise 1/2 to 1
turns.
 Rotate the chain tension adjustment ring counterclockwise
two clicks.
 Rotate the chain cover lock knob counterclockwise until
chain cover can be removed.
 Remove chain cover.
 Remove the bar and chain from mounting surface.
 Remove the old chain from the bar.
 Remove the slotted fastener with a screwdriver.
 Install the chain tension assembly on the new bar by in-
serting the alignment tab into one bar hole and installing
the screw through the other. Tighten securely.
Page 13 — English

Publicidad

loading