Publicidad
Idiomas disponibles
Idiomas disponibles
LED Display
Filter Button
HEATER Button
BUBBLE Button
Adjust the bubble level by pressing
the button (L1:300W, L2:500W, L3:720W )
DOWN Button
JET Button
LED display
°C
°F
Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically.
NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as
approximately 1°C.
Energy saving mode: Your spa will enter energy saving mode after 30 minutes of inactivity. In this mode, the screen
brightness will be reduced and unintentional touches to the button will not work. Tap any button (except UP/DOWN
button) to exit energy saving mode.
JET Button
JET button to turn the water jet massage function on and off. The JET button lights up when activated.
Press the
NOTE: The BUBBLE button can only be adjusted to L1 or L2 when the JET system is activated.
NOTE: The JET system will shut off automatically after one hour.
NOTE: The JET function cannot be activated when the water or ambient temperature is below 1°C / 33.8°F.
Adjust the jet nozzle to change the
water stream directions.
Screw the jet nozzle to change the
water stream strength.
HEATING
1. Press the
heating function is activated.
20-40°C
2. Pressing the
the desired temperature setting (from 20°C to 40°C ). The new and desired temperature setting will remain on the
LED display for 3 seconds to confirm the new value.
NOTE: The default temperature is 40°C.
NOTE: If the heating system is turned on, the filtration system will automatically start.
NOTE: When the water temperature is below 1°C (33.8°F), the anti-icing system will be activated automatically to heat
the water to 3°C (37.4°F).
IMPORTANT: The following conditions will lead to slow water heating
●
An ambient temperature lower than 10°C (50°F).
●
An outdoor wind speed above 3.5-5.4m/s (8-12mph).
●
If the air bubble function is activated when the heater is on.
●
If the spa cover is not properly in place when the heater is on.
CONTROLLER OPERATION
HEATER button to turn the heating system on/off. Both HEATER and FILTER button light up when
UP or
DOWN button will cause the LED to flash. When it is flashing you can adjust the water to
Jet Operation
11
Wi-Fi Icon
Low Temperature Warning
Ozone Button
Timer Button
Up Button
UVC Button
Publicidad
