Publicidad
Idiomas disponibles
Idiomas disponibles
Storage and Preparation for Future Use
1. Drain and clean the spa by following the "Drainage" and "Spa
Cleaning" sections.
2. Refer to the instructions to deflate air bladder.
3. Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the mild sun for
an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent
damage or leakage to the spa liner.
5. Prepare new additional cartridges for next time use.
6. Store the spa and accessories in a dry, temperature-controlled
environment, between 0°C and 40°C (32°F - 104°F). We recommend
storing the spa with desiccant.
7. The original packaging is recommended for storage.
8. After long-term storage, fill the spa with clean water and sanitizer,
and turn on the FILTER for at least 1 hour before use.
Installation
Low temperature will harden the PVC material and make it more fragile.
●
The new spa might have been stored or transported at a low temperature (below 4°C / 39°F) before it is unfolded. Put the
package indoors or somewhere warm for 12 hours to soften the material before use.
Heating and Heat Preservation
In cold weather, heating the water up will take much more time. It is suggested to:
●
Fill the spa tub with lukewarm water (not higher than 40°C / 104°F) to get it heated more quickly.
●
Use ground mat and inflatable bladder for better heat preservation effect.
●
When the outdoor temperature is below 4°C(39°F), even when not using the spa, as long as it is filled with water, the heater
should always be turned on (or put the spa in stand-by mode) to prevent water from freezing.
●
Your spa is equipped with an Anti-icing System. Put the spa in stand-by mode, when the ambient temperature is below 1°C /
33.8°F, the filter will run automatically. And when the water temperature falls below 1°C/33.8°F the heater will run automati-
cally. This will help prevent water from freezing. If you are not going to use the spa in near future, please disassemble the
spa and store it following the storage procedure.
●
When anti-icing system is activated, the system determines that the spa is in extreme cold condition that is not appropriate
for hydro massage. There will be a snow icon on the screen to indicate that. At this status, the JET function can't be activat-
ed. Please heat the water up to 20°C (68°F) or above to enjoy this function.
In Rainy days
For spa placed outdoors, do not use it when it rains.
If the spa is placed under rain shelter, do not turn on the bubble function. This is because the rain in the nearby air will also be
sucked into the pump, causing the bubble generator to get damp and rusty which could result in malfunction and void your
warranty.
It is recommended to put the plug and socket somewhere not exposed to rain to prevent damage caused by water accumulation
due to excessive rain.
DISPOSAL AND ENVIRONMENTAL PROTECTION
This mark indicates that the product should not be disposed of with other household waste. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, products should be
recycled responsibly to promote the sustainable reuse of material resources. Information on disposal can be
obtained from your local authorities.
To return your used device, please use the return and collection systems or contact the retailer where the
product was purchased for environmentally safe recycling.
PRECAUTIONS FOR WINTER USE
17
Publicidad
