Nidec Commander C200 Guia página 14

EN
Power and Ground connections
Connect the supply and motor connections using the cables and fuses quoted in the table shown in Step 4.
Figure 1-1 Size 5 and 6 power and ground connections
DC / Brake connections
Optional heatsink
mounted brake
resistor
Thermal
overload
protection
Optional external
device
braking resistor
DC + DC - BR
1
AC Connections
L1 L2 L3 PE
Optional EMC
filter
Optional
line reactor
Fuses
L1 L2 L3
Mains
Supply
Supply
Ground
The upper terminal block (1) is used for AC supply connection.
The lower terminal block (2) is used for Motor connection.
On size 5, the supply and motor ground connections are made using the M5 studs located near the
plug-in power connector.
On a size 6, the supply and motor ground connections are made using the M6 studs located above the
supply and motor terminals.
Commander C200/C300 Step By Step Guide
BR
+DC
-DC
2
Motor Connections
U V W
Motor
Optional ground
connection
6
15