Publicidad
Idiomas disponibles
Idiomas disponibles
English
helps to set the best combination of blade speed and aggressiveness needed to achieve a desired
cut rate and fineness. The pendulum knob is used to make the adjustment. The best pendulum
stroke setting for the particular work to be carried out can be obtained from the following table.
When using a knife blade, the pendulum setting should be 0. It is recommended the use of appro-
priate lubrication for cutting metal.
Position
Reciprocating
I
Pendulum movement (small)
II
Pendulum movement (average)
III
Pendulum movement (big)
ELECTRONIC SPEED REGULATION
The electronic speed control wheel is used to adjust the saw speed. In this way, the speed can be
adapted to the material being worked. Turn forward to increase and back to decrease speed. The
larger the number, the quicker is the speed.
Always hold the machine firmly closed to the surface to be processed. Start cutting only
when the motor attains full speed.
CUTTING
Cut at an even rate and take care not to overload the saw, excessive force on the saw will prevent
the pendulum action operating correctly and reduce the cutting efficiency. When cutting tight
curves, reduce or switch off the pendulum motion.
ANGLE CUTTING
Attention!
Always be sure that the tool is switched off and unplugged before adjusting the machine,
installing or removing accessories.
Cutting
Material
Steel, plastic
Fine cut of wood and plywood
Steel, aluminum, hard wood, plastic
Wood, plywood, plastic, quick cut of steel
and aluminum
Quick cut of wood and plywood
11
Publicidad
