Franke FRSM 302 C TD BK Manual De Instalación Y Servicio página 11

CLEANING AND MAINTENANCE
First of all remove stray food bits and grease drops from the cooking
surface with the special scraper (Fig. 4).
Then clean with speci c products for vitroceramic cooking surfaces with
a paper towel, then rinse with water and dry with a clean cloth.
Pieces of aluminum foil and plastic material which have inadvertently
melted or sugar remains or highly sacchariferous food have to be
removed immediately from the hot cooking area with the special scraper
(Fig.4).
Fig. 4
This is to avoid any possible damage to the surface of the top.
Under no circumstances should abrasive sponges or irritating chemical
detergents be used such as spot removers.
DO NOT USE STEAM CLEANERS.
TROUBLESHOOTING
ERROR CODE
F0
Electronic control
Fc
Electronic temperature
Ft/FE
sensor may be damaged
Fb Excessive key sensitivity
FU / FJ / FA / FC / Fd
Fr
CAUSE
Electronic error Disconnect and reconnect the power supply. If the error persists, calls after-sales support.
The cooking zones are switched o . Wait until the temperature is lowered. The cooking hob will start
overheated working again when the temperature returns to normal.
Wait until temperature is lowered. If the message persists even after the value returns to room
temperature, call the after-sales support.
Check that the glass-ceramic worktop has been installed properly. Call after-sales support to make sure
that keys touch the glass surface correctly.
This error is an automatic keypad check. It will disappear when the automatic check is reset to the correct
Touchpad error
value. If the error persists, contact the after-sales support.
There may be a problem with one of the relays. Disconnect the power supply, wait one minute and
Relay error
switch on again. If the error persists, call after-sales support.
When one makes use of heating elements, we advise receptacles with
at bottom (Fig. 5) having same diameter or lightly higher than that of
the hot area.
NO
Fig. 5
- Avoid over ows of liquid, therefore when boiling happens, or in any
case when liquid is heated, reduce the heat supply.
- Don't leave the heating elements on without receptacles on the top
or with void pots and pans.
If there is even a slight crack in the cooking surface, immediately
disconnect the power supply to avoid the possibility of electric shock.
SOLUTION
– 11 –
NO YES
EN