Basic Operations - Phonocar VM 041 Manual De Instrucciones

Basic operations

Power on / off
Pressany key on the front panel or the[POWER] key on the remote control to turn on the power under stan-
dby mode. The unit goes back to the last status after power on. Press and hold the [SRC] key on the front
panel or press the [POWER] key on the remote control to turn off the power under work mode.
Mute
Press the [MUTE] key on the front panel or remote control to mute the volume from the unit.
Press the [MUTE] key longly to hangup the phone
Notes: • Doing the operation above again or adjusting volume will release muting.
• Mute icon winks on the TFT during muting.
Volume adjustment
Turn the volume knob on the front panel or press the [VOL] key on the remote control. The adjustable range
of volume is 0 to 40.
Setting the Switch-on-Volume
The Switch-on-Volume is preset at level 10. This level can be modified as follows: With switched-on Unit,
regulate the Volume per requirement. Then press the Volume-knob until the volume-level will disappear from
the screen. This modified Volume-level will enter in force at the next switch-on of the Unit.
Open SOURCE MENU
Press the [SRC] key on the front panel or remote control or touch the top left corner of the screen to open
the SOURCE MENU. Do the above operation again to return to the original source.
Playing source selection
Open the SOURCE MENU, and then touch the source you desired or select one source by moving the cur-
sor and then confirm.
Notes:
• Playing source selection means selecting work mode, such as DVD mode, Radio mode, Camera mode, etc.
• When some devices are not ready, they cannot be selected.
Display system time
Press and hold the [DISP] key on the front panel to switch the display information between system time and
playing source when the TFT monitor is closed.
Using the TFT Monitor
Open / Close monitor: Press the [OPEN/CLOSE] key on the front panel or remote control to push the dis-
play panel out or in.
Change the monitor tilt angle: Due to the inherent character of LCD, you will get different vision impres-
sions when you watch it from different angles . The display angle of this unit can be changed; hence you can
select the best angle where you can get the best vision impression.
Press the [TILT] key on the display panel or the remote control to adjust the tilt angle one step at a time.
Press and hold the [TILT] key on the display panel or the remote control to adjust the tilt angle continuously.
Change aspect ratio : Press the [WIDE] key on the remote control to adjust the aspect ratio.
Image setting
1. Enter image setting mode. Press the [PIC] key on the remote control.
2. Select one item to adjust. Press the ( / ) keys on the remote control. Adjust the value
3. Press the ( / ) keys on the remote control.
4. Exit image setting mode To exit image setting mode, repeat the first step or stop operation for some
seconds.
Reset the unit
If the unit can not work correctly, you should reset the unit by pressing the [RESET] button on the front panel.
38