Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING OPERATION
DE
Load ON/OFF Setting
When the controller is powered on, press the button to control the load output.
EN
Battery Type Setting
Step 1: Enter setting mode by pressing button for 5s until the battery status
IT
Step 2: Select the desired mode by pressing button.
ES
Step 3: The mode will be saved automatically without any operation for 5S and
Batterie Typ
FR
Sealed (Default)
NL
GEL
Flooded
FI
PROTECTION
Battery Over Voltage Protection
DK
When the battery voltage reaches to the set point of Over Voltage Disconnect
Voltage (OVD), the controller will stop charging the battery to protect the battery
from being over charged to break down.
SE
Battery Over Discharge Protection
When the battery voltage reaches to the set point of Low Voltage Disconnect
Voltage (LVD), the controller will stop discharging the battery to protect the
battery from being over discharged.
Load Overload Protection
When the load is overloading (The overload current is ≥1.02 times, 1.05 times,
1.25 times, 1.35 times, 1.5 times the rated load current), the controller will
automatically cut off the output after 50s, 30s, 10s, 2s and 0.5s. User has to
reduce load appliance, then press the button or repower the controller.
Load Short Circuit Protection
Load will be switched off when load short circuit happens. User has to clear
short circuit, then press the button or repower the controller.
High Voltage Transients Protection
The controller is protected against small high voltage transients. In lightning
prone areas, additional external suppression is recommended.
LEDs are flashing.
LED will stop flashing.
CARBEST Power Solar Panel 135| 82507
LED 1
LED 2
ON
-
ON
ON
ON
ON
12
LED 3
-
-
ON
Publicidad
