Publicidad
5 Close the magazine. Make sure it is safely locked.
REMOVE STAPLES FROM THE MAGAZINE
1 Press the magazine latch
2 Slide the magazine
3 Remove the staples from the magazine.
4 Close the magazine. Make sure it is safely locked.
ACTIVATING THE TOOL
1 Make sure the tool is in good working condition.
2 Firmly press the safety yoke
pushed in a few millimeters
active now and ready for stapling.
STAPLING
1 Firmly press the safety yoke
pushed in a few millimeters.
2 Briefl y press the trigger
3 Release the trigger and remove the tool from the workpiece.
4 To fi re again, do steps 1 thru 3 again.
ACTIVE MODE/SLEEP MODE
• When the tool is in active mode it stays in this mode for 15 seconds
when there is no activity.
• After 15 seconds of inactivity, the tool goes into sleep mode. The
spring decompresses and you hear a sound. This is normal.
• Press the safety yoke
CHARGING OPERATING INSTRUCTIONS
! Do not use the tool whilst charging.
1 Connect the Micro-USB cable
2 Connect the Micro-USB cable to a USB-charger (not included).
3 Connect the USB-charger to a wall socket. The LED
during the charging process.
4 When the battery is fully charged, the LED turns green.
5 Disconnect the Micro-USB cable and remove the USB-charger from
the wall socket.
to unlock it from the tacker body.
backwards.
OPERATION
against the workpiece until it is
. The LED
against the workpiece until it is
.
to activate the tool again.
to the Micro-USB port
17
lights green. The tool is
fl ashes red
.
Publicidad
