Publicidad
! Charge only at ambient temperature between 10°C and 50°C.
! During the process of charging, the charger can become warm: this
is normal.
! Do not store the tool in locations where the temperature may exceed
50°C.
EXPLANATION OF LED LIGHT
LED red LED green
LED red LED green
! For better performance, press the tool fi rmly against the
workpiece.
! Look through the staple indicator
suffi cient staples.
! In case of a jammed staple, read the maintenance section. DO
NOT re-fi re the tool in order to clear the jam as this may damage the
tool.
! During operation, the tool may feel warm. This is normal but if the
tool starts to feel hot stop using the tool until it has cooled down.
STANDARD MAINTENANCE
1 Inspect all screws and tighten if necessary.
2 Keep all vents free from dust and dirt.
3 Clean the tool with a dry or damp cloth. NEVER use any solvent.
Operation/Usage
LED is continuously green
Tool is active and ready for next staple
LED fl ashes red and green alternately
Battery is low/empty
Charging with USB-charger
LED fl ashes red
Battery is charging
LED is continuously green
Battery is fully charged
MAINTENANCE
18
to see if the tool still has
Publicidad
