Publicidad
Idiomas disponibles
Idiomas disponibles
Congratulations with the purchase of your Twinmaster Controller
The Twinmaster is a software-controlled climate controller. The Twinmaster is suitable for one or two fans. The
Twinmaster also has an NTC (temperature sensor).
Usermanual
- Make sure The Twinmaster is securely attached
1
to on a wall.
- Attach the NTC (if possible) in the middle of
your room.
- Connect the fan or fans. Fans of the same
m3 don't give under pressure to your room.
2
Plug the Twinmaster into an earthed power
outlet.
3
Turn the left-hand knob
(1)
to the desired speed.
Minimum speed 20% to 60%. If the fans start to
hum gently, turn the left-hand knob
(1)
a little
higher until it is corrected. A to low fan speed
can damage thefan or fans or the Twinmaster.
4
(3)
Turn the right knob
to the desired
maximum speed (60% to 100%).
5
Now set the desired temperature with the
temperature knob (2). The NTC
now controls the processor for
optimum temperature control in your
Troubleshooting
Twinmaster 7Amp
If the Twinmaster fails to run:
1. Switch off the supply and check the fuse in
the IEC Connector.
2. If the fuse is OK increase the minimum fan
speed.
3. Re-connect the Twinmaster and retry.
Twinmaster 14Amp
If the Twinmaster fails to run:
1. Switch off the supply and check the fuse
(4)
in the Twinmaster.
2. If the fuse
(4)
is OK increase the minimum fan
speed.
3. Re-connect the Twinmaster and retry.
If the Twinmaster still fails please contact the
retailer the unit was purchased from.
Usermanual
NTC Temperature sensor 5m
1
4
Twinmaster
7/14Amp
Example
2
3
Publicidad
