KUMA Wireless WiFi Hotspot Kit Guía De Configuración página 2

Wireless WiFi Hotspot Kit
Easy Set
Up Guide
Once you have everything unboxed, begin
by sliding the cover off the lower part of
the wireless antenna by pressing the
bottom section with your thumbs then
push downwards to release you will hear
the clip click.
Wrap the blue USB cable around inside
the unit as shown in the picture. This is
to keep the cable tight inside the WiFi
Antenna to stop it falling out the
connection port inside the unit.
Replace the plastic cover on the unit to
ensure it stays water tight.
Next Plug your blue USB antenna cable
into the front of the router. Screw the small
black aerial on to the rear of the router.
Plug in and power on using AC or DC leads supplied. The
PWR light will remain solid while booting up. All lights apart
from PWR will start to flash. When the router has finished
booting up, you should have a PWR light, a USB light and
Wireless Button light (the grey button on the front) on solid.
This may take a few minutes.
Connect the WiFi on your device
(Smartphone/tablet/computer) to the 'USBWIFIRPT-3000A'
signal in your WiFi list in 'Settings'. At this point no password
is required to connect. Once you connect the device your
Wireless Button light will begin to flash, this light will continue
to flash when devices are connected to the router. Solid = no
devices connected. Flashing = devices connected
Next open a browser (Internet Explorer/Chrome etc.) on
your device and in the address bar type
press 'Enter'.
When prompted type:
User name = admin Password =
When you have logged in you will be greeted with all available
networks that your kit can see to connect to. The green,
yellow and red bars are to indicate the signal strength of the
WiFi connections available.
192.168.45.1 and
admin