Attach Handle; Before Starting The Engine - Briggs & Stratton ELITE Serie Manual Del Propietário

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

Attach Handle

You will need two 1/2" or 13mm wrenches to attach handle.
1. Attach handle to right side of generator frame (viewing
unit from front), as shown in Figure 2, with a 60 mm
capscrew, flat washers, nylon washers, and lock nut.
Figure 2 — Attach Handle
Lock Nut
NOTE: DO NOT overtighten. Handle must be able to
move up and down freely.
2. Raise handle and insert handle pin to move generator.
7000W Generator
Handle Pin
Flat Washers
60mm Capscrew
Nut
Washer
Handle Bracket
Nylon Washer
Nylon Washer
Handle Bracket
Washer
60mm Capscrew
Handle Pin
www.mymowerparts.com
BEFORE STARTING THE
ENGINE
Add Engine Oil and Fuel
• Place generator on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
WARNING
Fill tank to approximately 2-1/4" below top of neck to
allow for fuel expansion.
• Replace "1-1/2" with "2-1/4" fuel fill level given in engine manual.
• Failure to follow this instruction may cause fuel to overexpand
and spill from tank.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
7