Cooper Lighting Solutions Halo home HIWMA1BLE40A Instrucciones De Instalación

ENGLISH
HIWMA1BLE40A
In-Wall Smart Dimmer Installation Instructions
Turn OFF circuit breaker or remove fuse(s) and test that power is
•
off before wiring or servicing.
Never wire any electrical device with power turned on. Wiring
•
device with power on may cause permanent damage to product
and void warranty.
If you are not sure about any part of these instructions, please
•
contact a licensed electrician.
Minimum 75°C supply conductors
•
PACKAGING CONTENTS
A. Smart Dimmer B. (4) Wire Nuts C. (2) Screws
A. B.
The HALO Home Smart Dimmer requires a neutral wire for operation. If there is no
neutral wire at the current installation location, contact a licensed electrician.
The HALO Home Smart Dimmer easily replaces a single location standard dimmer
or switch to allow ON/OFF and dimming control of standard lighting via the HALO
Home app and HALO Home Controllers.
Max Loads: 600W INC/ELV/FLR/Halogen/MLV; 300W LED/CFL
If there is more than one control location for the same lighting or switched load
(3-way or 4-way), additional HALO Home products will be needed:
•
One location will need a HALO Home Smart Dimmer. This will operate as a single-pole
dimmer controlling the lighting load.
•
The other dimmer location(s) will require HALO Home Accessory Dimmers*. These will send
wireless signals to the Smart Dimmer which will turn ON/OFF the lighting/load.
*
Other HALO Home Controllers like the Accessory Switch, Anyplace Dimmer or Multi-Room Scene
Keypads can also be used.
Accessory
Dimmer
Wireless Signal
Constant Power
ONLY USE WITH NON-SMART LIGHTS
C.
SINGLE LOCATION OVERVIEW
MULTI-LOCATION CONTROL OVERVIEW
Accessory Smart
Dimmer Dimmer
Edges may be Sharp - Wear gloves while handling.
•
Connect dimmer to a 120 volt, 60 Hz power source. Any other
•
connection voids the warranty.
Fixture should be installed by persons with experience in household
•
wiring or by a qualified electrician. The electrical system, and
the method of electrically connecting the fixture to it, must be in
accordance with the National Electrical Code and local building codes.
ITEMS REQUIRED (Purchase separately)
• Philips Screwdriver
• Labels or electrical tape for tagging wiring
• Voltage tester
• Tape or labels (3- or 4-way wiring)
• Gloves
Max wattage derating
INC/ELV/FLR/Hal/MLV
LED/CFL
TIPS: When retrofitting existing 3-way
or 4-way locations:
• Verify that there is a neutral wire at
EACH dimmer location. (White wires
connected to dimmer terminals
and marked with electrical tape are
typically NOT neutral wires.)
• Only 1 HALO Home Smart Dimmer
will be used in the circuit.
• The HALO Home Smart Dimmer must
be directly connected to the
lighting load.
• HALO Home Accessory Dimmers
cannot wire downline of a Smart
Dimmer. They require a constant hot
feed (unswitched and undimmed).
• HALO Home Accessory Dimmers can
be powered from a different circuit
than the lighting/Smart Dimmer if
necessary.
3-way and 4-way wiring can be
confusing. If wiring does not match
diagrams shown, stop and consult with
an electrician.
1-Gang 2-Gang 3-Gang
600W/VA 550W/VA 500W/VA
300W 300W 300W