Publicidad
Idiomas disponibles
Idiomas disponibles
Rating plate
The technical data for the appliance can be found on the rating plate on the back of the appliance. Never
remove the rating plate from the appliance. The setting values are specified on a label on the appliance
packaging.
Guideline for ventilation
This appliance may only be set up in a sufficiently ventilated room and according to the applicable regulations
and ventilation requirements. Please note that the air volume required for combustion must not be below 2
m3/h per kW of power (see kW total power on the rating plate).
INSTALLATION
This appliance is always supplied with a set of adjustable feet and, depending on the model, with a splash
guard. The appliance may also be used without the splash guard.
Fitting the adjustable feet (only for specific models)
Beforehand:
• Remove all parts that are not permanently fixed, especially the pan
supports and burners.
• Remove the accessories from the oven.
Proceed as follows:
• Tilt the appliance by raising one side slightly from the floor.
• With the plates in position, screw the adjustable feet into the mounting
holes on the underneath of the appliance.
• Repeat the process on the other side. You can make the final adjustments
to the feet in order to level the appliance once the gas and electricity supply
have been connected. If it is necessary to pull the appliance, screw the
adjustable feet in fully. Make the final settings only when the other
installation tasks have been completed.
ELECTRICAL CONNECTION
Only a licensed expert may connect the appliance.
The appliance must be installed according to the most recent IEE regulations (Institute of Electrical
Engineers).
The appliance could become damaged if incorrectly connected.
Make sure the voltage of the power supply corresponds to the specified value on the rating plate. The rating
plate can be found on the inside of the storage compartment flap.
Ensure that the power supply is properly earthed and that the fuse and the wiring and piping system in the
building can withstand the load from the appliance.
It is recommended that you configure the circuit for the appliance to 16 A.
E ng li s h - 3
Publicidad
