Atlas Copco CD65 Libro De Instrucciones página 8

CD65 – CD80 – CD100 – CD140 – CD170 – CD230 – CD280 – CD390 – CD520
Abbreviation Designation Function
Mod Modify To modify programmable settings
Prog Program To program modified settings
Rset Reset To reset a timer or message
Rtrn Return To return to a previously shown menu
Xtra Extra To find the module configuration of the regulator
Display
Normally, the display shows the operation status of the dryer, the
pressure in the vessels and the abbreviations of function keys F1, F2
and F3. The main screen looks as follows:
Vessel A
bar 7.0
Regenerating
Menu
F1 F2
Calling up other menus
Starting from the Main display:
~
– Use the key for a quick look at the actual dryer status
– Press the key Menu (F1). The option "Status data" will be
followed by a horizontal arrow:
– Press the tabulator key to select this menu.
~
– Use the key to scroll until the desired submenu is followed
by a horizontal arrow and then press the tabulator key to
select this menu.
For detailed instructions, consult the User manual for Elektronikon
regulator.
Function of control programs
Program/ Description
Function
Main Shows in short the operation status of the dryer.
It is the gateway to all functions.
Status data - Protections
- Service
- Expansion Mods
Measured data Calling up:
- actually measured data
- status of some inputs
Counters Calling up the:
- running hours
- regulator (module) hours
Test Allows a display test.
Modify params Modifying the settings for:
- parameters
- protections
- service plans
- clock functions
- configuration (time, date, display language, ...)
Service Calling up service plans and resetting the timers.
6
B
0.5
~
B
Unld
F3
Main screen
Program/ Description
Function
Saved data Calling up the saved data: last shut-down, last emergency stop
data
Counters menu
Function
To allow the operator to call up the:
– running hours
– regulator (module) hours (the hours the module has been under
tension)
Procedure
1. Starting from the Main screen:
– press the key "Menu" (F1)
~
– press the key until the option "Counters" is followed by a
horizontal arrow
– press the tabulator key to activate the menu
~
2. By pressing the key, the above-mentioned data can be found.
Test menu
Function
To carry out a display test, i.e. to check whether the display and LEDs
are still intact.
Procedure
1. Starting from the Main screen:
– press the key "Menu" (F1)
~
– press the key until the option "Test" is followed by a
horizontal arrow
– press the tabulator key to activate the menu
2. The option "Display test" will be followed by a horizontal arrow.
3. After pressing the tabulator key, the regulator will generate a
series of patterns on the display which enable the operator to
check that each pixel still functions normally; at the same time the
LEDs are lit.
2904 0177 04