Publicidad
Idiomas disponibles
Idiomas disponibles
(E)
(E)
(E)
STEP E. Have two persons to move the fireplace box to the wall hole.
If the appliance is fully recessed into the wall:
• Use the 6 screws (provided) to lock the appliance into the wall with the existing two side
flanges, see Figure (E)
• Install the media and re-install the glass front.
If partial recess into the wall:
• Use the four mounting metal brackets (supplied) to lock the appliance to the wall, see Figure ( F )
NOTE: Using the existing holes on sides of the appliance for recessing into wall.
STEP F. Fireplace will be like this after installation Figure (G)
Wall Mounted Installation
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
A. Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
B. Have two people hold the appliance against the wall to determine the final location.
C. Place unit face down on a soft, non abrasive surface. Remove the bracket from the back of the unit by removing
the screws, refer to Figure 1.
D. Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket
MUST have the hooks facing upward and be level. NOTE: It is strongly recommended that the
mounting bracket (E) be Screwed into
the wall studs Where possible. If the
wall Studs cannot be used, ensure
That the supplied plastic anchors are
used to affix the bracket to the wall
and the bracket is adequately
secured.
E. With the wall mounting bracket installed have two people lift the appliance up and insert the two hooks
on the bracket into the two slots on the back of the appliance.
F. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
16
Publicidad
