Getting Started; Unpacking; Installing And Charging Batteries - ATP ZX-1A Manual Del Propietário

WARNING: PERSONAL INJURY HAZARD
Do not use this Leak Detector in an explosive or combustible atmosphere. The
ambient atmosphere is drawn through the probe and sensor which operates at a very
high temperature.
The resulting hot mixture of air and combustible gas could explode.

Unpacking

Unpack the unit from the carton and carrying pouch. Refer to the Parts and Controls section
(page 3) for parts identification. You will find five (5) major components in the carrying case.
- Unit
- Battery pack
- Sensor
- Probe
- Battery charger
Before using your new leak detector for the first time, you will need to charge the batteries,
install the sensor and install the probe.

Installing and Charging Batteries

CAUTION: Batteries should only be charged in temperatures between 50ºF and 104ºF
(10ºC - 40ºC). Charging batteries outside this temperature range may cause
permanent damage to the batteries.
A new unit comes shipped with the battery pack partially installed and taped in place. Remove
the tape holding the battery pack, remove the battery pack, and then remove the tape and pack-
ing material inside the battery pack compartment, covering the battery socket.
Re-insert the battery pack, NOTING THE CORRECT ORIENTATION, indicated by the 'rib' and
square peg on one side of the pack and corresponding groove in the instrument's compartment
(see Fig 2).

GETTING STARTED

4
FIG 2