Descargar Imprimir esta página

SOMFY PERGOLA 50 io RGS Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 86
EN
3.4.2.Setting the fabric tensioning with automatic catching system at lower end
limit
NOTICE
• This function is used to adjust the fabric tension of the motorised product on
3 threshold levels (strong-medium-weak).
• By default, fabric tension level is set on medium.
To adjust the fabric tension:
1] Place the motorised product at its half-way position.
2] Briefly press the my and Down buttons simultaneously, immediately followed
by pressing and holding the my and Down buttons simultaneously until the
motorised product moves up and down briefly.
NOTICE
The drive is now in set mode for ten seconds only.
3] Adjust the fabric tension using the Up or Down buttons.
ð To increase the tension on the fabric, press the Up button until the
motorised product moves up and down slowly: the fabric tension of the
motorised product passes to the upper threshold.
ð To decrease the tension on the fabric, press the Down button until the
motorised product moves up and down slowly: the fabric tension passes
to the lower threshold.
4] To validate the setting, press the my button until the motorised product
moves up and down briefly.
3.4.3.Setting the detection level of sensitivity in case of obstacle
NOTICE
Level 2 is the factory level
To customize the obstacle detection threshold:
1] Move the motorised product to the middle position.
2] Briefly press simultaneously the Up and my buttons then immediately press
simultaneously the Up and my buttons again for 2 seconds until an up and
down movement.
3] Press the Up or Down button to increase/decrease the closure or opening
level of 1 to 3.
4] Press the my button until an up and down movement to save the chosen
level.
3.5.Programming the first local io-homecontrol point
NOTICE
Programming (final) of the first control point is possible only if the end limits of the motorised product are set.
3.5.1.Programming the pre-programmed io-homecontrol point
Press the Prog. button of the preprogrammed control point: the motorised product
briefly moves up and down; the control point is programmed definitively.
10
PERGOLA 50 io RGS
1]
2]
0.5 s
3]
4]
1]
3]
©
Copyright
2022 SOMFY ACTIVITES SA. All rights reserved.
PERGOLA 60 io RGS
5 s
2]
+
4]
0.5 s

Publicidad

loading

Este manual también es adecuado para:

Pergola 60 io rgs