EINHELL GE-ULB 18 Li E Kit Manual De Instrucciones Original página 20

If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.6 Battery capacity indicator (Fig. 8)
Press the button for the battery capacity indicator
(A). The battery capacity indicator (B) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Anl_GE-ULB_18_Li_E_Kit_SPK7_BH.indb 20
GB
6. Operation
Caution!
If you point the air fl ow at other people, animals or
objects (e.g. windows), this could cause injuries
and damage. Check that all the components are
correctly seated.
•
Point the air flow away from yourself.
•
Never point the air flow at other people, ani-
mals or objects.
•
Do not blow away any hard objects such as
stones or branches.
6.1 Switching the machine on/off (Fig. 9)
a) Switching on:
To switch on, press and hold the On/Off switch
(Item 6).
b) Switching off :
Let go of the On/Off switch (Item 6).
6.2 Controlling the speed (Fig. 9/10)
The equipment comes with electronic speed
control for setting the blowing velocity. The
blowing velocity depends on the setting of the
speed controller (Item 5). The number of LEDs
which appear on the display (Item 4) correspond
to the selected blowing velocity.
1 LED = lowest blowing velocity
5 LEDs = highest blowing velocity
1. Switch on the machine (Section 6.1). The
number of LEDs corresponding to the
blowing velocity will appear on the display
(Item 4).
2. Turn the speed controller (Item 5) counter-
clockwise to reduce the blowing velocity,
turn it clockwise to increase it. The speed
controller will make an audible click when the
maximum blowing velocity (5 LEDs on the
display) is reached.
Use the equipment only with the blowing velocity
needed for the job.
6.3 Leaf blower (Fig. 1)
•
Turn on the equipment (see section 6.1).
•
Set the desired blowing velocity with the
speed controller (see section 6.2).
•
Direct the air stream forward and walk slowly
to blow foliage or garden refuse into a pile or
to remove it from hard-to-reach places.
- 20 -
10.10.2022 09:39:08