Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SM 2610028628 01-13 E_SM 2610028628 01-13 E.qxp 1/11/13 2:46 PM Page 6
Double Insulated Tools
Double insulation
power tools which eliminates the need for the three wire
grounded power cord and grounded power supply system. It
is a recognized and approved system by Underwriter's
Laboratories, CSA and Federal OSHA authorities.
Servicing of a tool with double insulation
WARNING
requires care and knowledge of the system
and should be performed only by a qualified service
technician.
Replace damaged cords immediately. Use
WARNING
of damaged cords can shock, burn or
electrocute.
If an extension cord is necessary, a cord
WARNING
with adequate size conductors should be
used to prevent excessive voltage drop, loss of power or
overheating. The table shows the correct size to use,
depending on cord length and nameplate amperage rating of
tool. If in doubt, use the next heavier gauge. Always use U.L.
and CSA listed extension cords.
Connection to a Power Source
is a design concept used in electric
Extension Cords
"SAVE THESE INSTRUCTIONS"
WHEN
SERVICING,
WARNING
IDENTICAL REPLACEMENT PARTS.
POLARIZED PLUGS. To reduce the risk of
WARNING
electrical shock, your tool is equipped with a
polarized plug (one blade is wider than the other), this plug
will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. To
reduce the risk of electrical shock, do not change the plug in
any way.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Tool's
Cord Size in A.W.G.
Ampere
Cord Length in Feet
Rating
25
50 100 150
3-6
18
16
16
6-8
18
16
14
8-10
18
16
14
10-12
16
16
14
12-16
14
12
—
NOTE: The smaller the gauge number, the heavier the cord.
6.
USE
ONLY
2
Wire Sizes in mm
Cord Length in Meters
15 30
60 120
14
.75 .75 1.5 2.5
12
.75 1.0 2.5 4.0
12
.75 1.0 2.5 4.0
12
1.0 2.5 4.0
—
—
— —
—
—
Publicidad
Tabla de contenido
