Taurus Alpatec FOREST Manual De Instrucciones página 6

English
TRIANGLE FAN
FOREST
DESCRIPTION
1 FAN HEAD
2 OSCILLATION KNOB
3 ON/OFF SPEED (0/I//II//III)
4 CONNECTOR
5 TILT ADJUSTMENT KNOB
6 LOCATING SCREW
7 FIXING BOLT
8 NECKING FIXING KNOB
9 INNER PIPE
10 TRIPOD BRACKET WITH HEIGHT AD-
JUSTMENT SCREW
11 PLASTIC RING
12 TRIPOD BASE
13 END CAP (FOR LEGS)
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not remove the support feet of the
appliance.
- Do not move the appliance while in use.
- Use the appliance handle/s, to catch it or move
it.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Make sure that dust, dirt or other foreign
objects do not block the fan grill on the
appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
- Do not use the appliance to dry pets or
animals.
- Do not use the appliance to dry textiles of any
kind.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- Do not remove the support feet of the
appliance.
- Ensure that the appliance is level with respect
to the floor.
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base
feet fitted.
FITTING THE BASE (FIG.1):
- To ensure stability of the Tripod Base, pull each
leg outwards until it latches or clicks in place
on the Tripod Bracket. Place the Tripod Base
upright on the floor.
- Loosen the Height Adjustment Screw and
insert the Inner Pile through the hole in the
Tripod Base. Tighten the Height Adjustment
Screw to fix the Inner Pipe to the Tripod Base.
- Slide the plastic Ring onto the Inner Pile from
the bottom of the assembly. Fix it in place using
the screw. This prevents the Inner pipe from
being pushed out when adjusting the Height.
- Attach the End Cap to bottom of the Inner Pipe