Taurus Alpatec FOREST Manual De Instrucciones página 7

ASSEMBLING THE FAN HEAD (FIG.2)
- Remove the Neck Fixing Bolt and Knob from
the top of the Inner Pipe.
- Remove the Tilt Adjustment Knob from the
neck of the Motor Unit; place the neck over the
Inner Pipe with Locating Screw aligning with
the slot on the side of the pole. (See Figure 2.1)
- Run the Neck Fixing Bolt through the neck of
the Motor Unit and the Inner Pole and tighten
the Locating Screw leaving approximately 3mm
gap under the screw head. (See Figure 2.2)
- Fix the Neck Fixing Knob to the Neck Fixing
Bolt and fix the Tilt Adjustment Knob to the
neck of the Motor Unit.
- Now you can adjust the tilt of the Motor
- Unit and secure it in position by tightening the
Tilt Adjustment Knob.(See Figure 2.3)
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Prepare the appliance according to the function
you wish to use:
USE:
- Extend the cable completely before plugging
it in.
- Attach the appliance to its base making sure
that it is correctly fitted into place.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using the selection
knob.
- Select the desired speed.
FAN FUNCTION:
- Select the fan position.
- Select the desired ventilation speed.
OSCILLATION FUNCTION:
- The oscillation function makes it possible to
direct the flow from the apparatus so that it
automatically alternates over a range of 75º.
- To activate this function, turn the knob (2).
- To deactivate this function, follow the
procedure for switching it on in reverse.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance, selecting position 0 on the
selector control.
- Unplug the appliance from the mains.
- Clean the appliance.
CARRY HANDLE/S:
- This appliance has a handle on the upper
part of the body, which facilitates comfortable
transportation.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.