Parkside PTBM 500 E5 Traduccion Del Manual De Instrucciones Originale página 70

GB MT
Operation
Caution! Risk of injury!
- Ensure that you have suficient
space in which to work and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device.
Spindle-side drive
pulley (
Pos.
1. D - I
2. D - II
3. C - I
The gear cover (3) is equipped with a interlock switch (32). If the gear cover (3) is
not closed correctly, the device cannot be switched on.
6. Using the lever (33), slide the motor
unit (13) backwards to re-tighten the V-
belts (29).
7. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
70
All manuals and user guides at all-guides.com
30)
A
B
C
D
speed
Pos.
[1/min]
500 4. D - III
680 5. B - I
770 6. C - II
Setting up
Place the bench drill on a solid surface.
Ideally, bolt the drill to the surface. Use the
four holes in the baseplate (17) for this.
Selecting the speed
1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Release the retaining screw (12) on the
motor unit (13).
4. Using the lever (33), slide the motor
unit (13) forwards a little to release the
load on the V-belts (29).
5. Place the V-belts (29) on the desired
assembly to reach the speciied speed:
Motor side drive
pulley (
I
II
III
speed
Pos.
[1/min]
830 7. B - III
980 8. A - II
1100 9. A - III
8. Re-tighten the retaining screw (12) on
the motor unit (13).
9. Close the gear cover (3). Fasten the
locking bolt (11) on the gear cover .
31)
speed
[1/min]
1600
2000
2500