Dish
Quantity
of food
and
water
Rice
1/3
Milk rice
1/3
Ribs
1/2
Knuckle of
1/2
pork
Veal
1/2
Chicken
1/2
Fish
1/3
Lamb
1/2
Rice cro-
2/3
quettes
Corn
2/3
Sweet
2/3
potato
Morels
2/5
ANOMALIES AND REPAIR
- If the cooker is not functioning correctly, turn of the hob immediately, place the cooker on a flat
surface and rinse slowly with cold water to cool it and reduce the pressure. The pressure cooker
may only be used again once the cause of the fault has been resolved.
- Take the appliance to an authorised technical support service if problems arise. Do not try to
dismantle or repair without assistance, as this may be dangerous.
If any anomaly is detected, check the following table
Anomalies
The pressure release
selector valve makes a
noise and does not release
steam after the cooker is
heated.
The safety valve releases
steam or liquid.
Steam is coming out of the
safety grille.
Steam is escaping from
underneath the lid
Cooking time after
stable actuation of
the pressure release
selector valve and on a
low heat (minutes)
4 – 8
8 – 12
8 – 10
15 – 20
15 – 20
10 – 15
4 – 8
10 – 15
10 - 15
5 - 8
6 - 10
15 - 20
Causes
Blockage of the pressure release
selector valve
Blockage of the air release pipe
Cooking without liquid
The hob is inclined
Blockage of the air release pipe
The pan has been overfilled
The heat source is too strong
The lid has become misshapen.
Malfunctioning of the pressure
release selector valve and safety
valve
The sealing joint is not properly
fitted
Damaged joint
Blockage of the O-ring
Lid closed badly
Pressure
Cooking once
position
cooled
60 kPa
Done
60 kPa
Done
100 kPa
The meat se-
parates from the
bone
100 kPa
The meat se-
parates from the
bone
100 kPa
Well done
100 kPa
The meat se-
parates from the
bone
60 kPa
Done
100 kPa
Done
60 kPa
Done
60 kPa
Done
60 kPa
Done
60 kPa
Well done
Solutions
Clean the pressure release
selector valve
Remove the dirt
Immediately turn off the hob,
remove the cooker, reduce the
pressure and check the cooker.
Heat the cooker on a flat, stable
hob
Remove the dirt
Reduce the filling quantity
Adjust the heat source to the
steam being released by the
pressu- re release selector valve
Change the lid.
Remove the dirt from the
pressure release selector valve
and safety valve
Fit the sealing joint correctly
Replace the sealing joint
Clean the sealing joint
Close the lid correctly
Observation
Cut into
chunks
Chopped
In cubes
Whole
chicken
Chopped