Ego Power+ CH7000E Instrucciones Originales página 8

CHARGING A HOT OR COLD BATTERY PACK
EN
If the battery pack is out of the normal temperature
range, LED 3 will shine red. When the temperature of
the battery pack returns to 3°C to 57°C, the charger will
automatically begin charging and the corresponding LEDs
on the charger will shine normally.
DEFECTIVE BATTERY PACK OR CHARGER
If the charger detects a problem, LED Indicator 3 will flash
red or all the LEDs will turn off.
1. Remove and reinsert the battery pack in the charger.
If the LEDs still read "defective", try charging a
different battery pack.
2. If a different battery pack charges normally, dispose
of the defective battery pack (refer to the instructions
in the battery pack manual).
3. If a different battery pack also indicates "defective",
unplug the charger and wait until the flashing LED
3 goes out, then reconnect the charger plug to the
power supply. If no charger LEDs shine green briefly
simultaneously for self-inspection at the plugging
moment or LED 3 on charger still display defective,
the charger may be defective.
WALL MOUNTING HOLES
The charger has mounting holes for convenient storage
(Fig. A). Install screws in the wall 76mm apart. Use screws
sufficiently strong to hold the combined weight of the
charger and battery pack.
MAINTENANCE
WARNING:
To avoid serious personal injury, always
remove the battery pack from the tool before cleaning or
maintenance.
WARNING
: When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.
WARNING : It is not recommended to use
compressed dry air as a cleaning method of the charger. If
cleaning with compressed air is the only method to apply,
always wear safety goggles or safety glasses with side
shields when cleaning the tool. If the operation is dusty,
also wear a dust mask.
8
700W RAPID+ CHARGER — CH7000E
WARNING:
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloth to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician at an EGO Service Centre.
Protecting the environment
Do not dispose of electrical equipment,
battery charger and batteries/
rechargeable batteries into household
waste!
According to the European law
2012/19/ EU, electrical and electronic
equipment that is no longer usable, and
according to the European law
2006/66/EC, defective or used battery
packs/batteries, must be collected
separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get into
the food chain, damaging your health and
well-being.