Vortice CA MD RF Manual De Instrucciones página 11

ENGLISH
Typical applications
See Figures 1-5;
The images shown refer to typical applications for this
product.
In particular, in Figure 1, it is possible to check the
correct orientation of the product from duct:
A = intake
B = delivery
Installation
See Figures 6-12.
The images shown are purely indicative.
purpose is to illustrate the main assembly steps for the
entire range.
IMPORTANT: See the "Wiring Diagrams" paragraph to
check the 3 ventilation speeds.
IMPORTANT
If the unit does not have piping connected to the
suction point (free suction) and it is installed at a height
lower than 2.3 m, assembly of the protection grille -
suction side (fig. 6-7) is required.
Wiring diagrams
See Figure 13
Connection with the optional device upon request is
foreseen to check ventilation speeds (device not
supplied in packaging):
- 13A) Vortice 3-speed selector Code 12866 o 1289.
IMPORTANT
Vortice guarantees correct product operation and
control only when paired with the Vortice 3-speed
selector (Code 12.866-12891).
Other types of connection
Alternatively, other connection diagrams are available,
associated to different control modes (devices
provided by the installer).
Connection alternative for new installation
- 13B) max
- 13C) med
- 13D) min
Machine replacement on existing system
Connection without modifications to the electrical
system: the same switches as on the existing system
will be used.
Maintenance / Cleaning
Fig 14-17.
Disposal
This product complies with Directive 2012/19/EU on
the management of waste electrical and electronic
equipment (WEEE).
The crossed-out wheeled bin symbol on the ap-
pliance indicates that, at the end of its life, the pro-
duct
should not be discarded together with household
waste but must be taken to a separate collection
Their
point for electrical and electronic equipment. This will
avoid negative effects on the environment and
health, and will encourage correct treatment, disposal
and recycling of the materials from which the
product is made.
Contact the municipal authority for
the location of this type of facility. Al-
ternatively, the distributor is obliged
to take back the appliance to be di-
sposed of free of charge in ex-
change for the purchase of an
equivalent
appliance.
11