Levoit Dual 100-RBW Guia Del Usuario página 12

EN
Storing
Follow the cleaning instructions (see page 10) and allow all parts to dry completely before
storing. Store in a cool, dry location.
T R O U B L E S H O OT I N G
Problem
Humidifier doesn't turn
on, or the buttons do
not work.
Little or no mist comes
out.
Humidifier is hot (or the
water inside is hot), and
little or no mist comes
out.
Humidifier uses water
too quickly.
12
Possible Solution
Unplug the humidifier and plug it back in. Press
humidifier on.
Fill the water tank if it is empty.
Press to use a higher mist setting.
Make sure the mist tube is correctly installed (see
Mist Tube, page 11).
Make sure the water level in the base is not too high.
Water may be dirty, and there may be mineral buildup inside
the base. Clean the transducer with a cleaning brush and white
vinegar and make sure all parts are properly installed (see
& Maintenance, page 10). Fill with clean water.
Make sure the mist outlet and air inlet are not blocked (see
Getting to Know Your 2-in-1 Humidifier &
Make sure the air inlet at the bottom of the humidifier and the
mist outlet at the top of the humidifier are not blocked. Do not
place the humidifier on floors, carpets, rugs, or surfaces with
fibres that may block the air inlet.
Make sure the mist tube is correctly installed (see
the Mist Tube, page 11). If the mist tube is not in place, the
humidifier will not create mist, and the water temperature will rise.
This is not dangerous, but the humidifier will not work correctly
until the mist tube is put in place.
The humidifier uses up water based on the environmental
temperature and humidity. If your environment is cold and/or dry,
the humidifier will run out of water faster.
to turn the
Installing the
Care
Diffuser, page 5).
Installing