SPEX SLWZ-DIM-01 Manual Del Usuario página 3

Before you start
IMPORTANT:
Review this installation guide in its entirety before starting installation of
your Smart Dimmer Switch or removal of your old switches. Installation and maintenance
involving electrical wiring must be done by qualifi ed person(s). Risk of Electric Shock:
Electricity can cause personal injury and property damage if handled improperly. An
external air gap switch shall be installed before circuit connection to this device. The
metal heatsink plate is not grounding, which might become live. Install with plastic Cover
Plate only.
NOTE: INSTALLATION OF THIS SMART DIMMER REQUIRES
A NEUTRAL WIRE. IF NEUTRAL WIRE IS NOT CONNECTED,
THIS DIMMER WILL NOT WORK. CONSULT A QUALIFIED
ELECTRICIAN.
Caution: To reduce the risk of injury and/or overheating and damage to other equipment:
• Make sure that the power at the circuit breaker is turned OFF before starting.
• A neutral (typically white) wire is required.
• Replace single pole switches ONLY. Not compatible with 3-way switches.
• The wire colors indicated in this manual are typically found and may differ in some
constructions / regions.
• Ensure the wire conductors are securely fastened to each wire.
• It is recommended that a certifi ed electrician completes all high voltage electrical
installations.
• Must follow all building and electrical codes in the region when installing.
• Do not install to control an appliance, motor or receptacle.
• Recommended to be installed in a minimum 2.5" depth device box.
• Do not mix different load types or different luminaires on the same dimmer.
• Dimmer does not work with smart bulbs or fi xtures.
• Intended for installation in an in-wall electrical box.