Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SET UP & USE
FOLLOW ME
Parts of the room are cooler where there is a draft. Other parts are warmer due
to direct sunlight. The FOLLOW ME Function allows the room to be cooled
according to the room temperature, wherever the remote is located.
• This function can be activated from the remote control ONLY. The remote
control serves as a thermostat allowing for the precise temperature control at
its location.
• To activate the Follow Me function, point the remote control towards the
appliance and press the FUNCTION
• Press either the
the LED screen.
• Press the Menu
on the LED screen.
• The remote will display the actual temperature at its location. The remote
control will send this signal to the air conditioner at 20 minute intervals.
• If the unit does not receive the Follow Me/Temp Sensing signal during a 25
minutes interval, the follow me function will be canceled and will need to be
reactivated.
• To cancel this function, press the
until the
flashes on screen, and then press the
cancellation. The
NOTE: · The remote must be within 23 feet of the remote control receiver on the
air conditioner unit. It should not have any obstructions.
TIMER
BUTTON
• The timer can be used to delay the appliance start-up or shutdown.
PROGRAMMING START-UP
• With the appliance ON select the settings that you would like to program
at start-up. Example: COOL Mode, temperature, fan speed. Turn OFF the air
conditioner.
• Press the
symbol will flash
• Press the
switch on using the buttons (from 30 minutes to 24 hours).
• During the first ten hours you can select half hour intervals. For times longer
than ten hours, one hour intervals can be selected.
• Press the
Page 22
OR
button until the FOLLOW ME
button. The FOLLOW ME
will stop flashing and disapperar from the screen.
button twice, the LED screen will display hours, the
.
or
button to set the time when you want the appliance to
button again to activate the selected time. The
button.
will stop flashing and illuminate
, then press either the
button to confirm the
symbol flashes on
or
button
symbol and
symbol and
Publicidad
