Connecting Disposer To Mounting Assembly - Westinghouse 1600061 Manual Del Usuario

Installation (continued)
CONNECTING THE DISPOSER TO THE
MOUNTING ASSEMBLY
- Adjust the disposer position to make the elbow line up with the
trap (see Fig. 11).
- The disposer must be installed so that the reset button is
readily accessible (see Fig. 12).
- Make sure the cushion mount is properly in place. Line up
the disposer under the mounting assembly. Lift and guide the
disposer so that all three tabs of the bottom supporting ring
engage the steps of the top supporting ring. Turn the bottom
supporting ring counter-clockwise until it is fully engaged and
the tool mount comes in contact with the top supporting ring.
Insert a screw driver into the tool mount for added leverage, if
needed (see Fig 13a).
If you are unable to fully engage the bottom supporting ring,
release and lower the waste disposer (see Fig 13b).
QKG06
Web: www.conglom.com/documentation/
Sink
Mounting
Assembly
Top
supporting
Step
ring
Cushion Mount
Bottom
Tab
supporting
Tool
ring
Mount
Fig.13
8
Fig. 11
Elbow
Trap
Disposer body
Reset Button
Fig. 12
Sink
Tool Mount
Fig.13a
Fig. 13b