Attaching Discharge Elbow; Removing Knockout Plug - Westinghouse 1600061 Manual Del Usuario

Installation (continued)
If at any time the bottom supporting ring becomes disengaged
from the body of the waste disposer, then:
1. Align the slot in the bottom supporting ring with tab on the
waste disposer body.
2. Lower the bottom supporting ring and make the slot fit in the
tab.
3. Turn the bottom supporting ring counter clockwise to secure it
in place.

ATTACHING DISCHARGE ELBOW

- Take off the elbow gasket from the discharge elbow first, then
attach the flange to the discharge elbow, then reset the elbow
gasket (see Fig. 9a).
- Make sure the elbow gasket is attached to the discharge elbow
correctly (see Fig. 9b).
- Connect the discharge elbow to the disposer (see Fig. 9c).

REMOVING KNOCKOUT PLUG

If you are using a dishwasher, complete the following procedure. If no
dishwasher is to be connected, skip this section.
- Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug (see Fig. 10). Do not use a
screwdriver or sharp instrument. When the knockout plug falls
into the disposer, you may remove it, or grind it up when the
disposer is being used. This will not damage the disposer in
any way, but may take some time to grind.
Slot
Tab
Elbow
Gasket
Discharge
Elbow
Metal Dowel
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance.
Flange
Elbow Gasket
Groove
Fig. 9b
Discharge Elbow
Fig.9a
Fig.9c
Knockout
Plug
Wood or
Fig. 10
CONGLOMKB.COM