1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Drill an installation hole (4) with a
diameter of 50 mm and min. 67 mm depth
to properly install the luminaire.
3. Connect the connection cable of the
luminaire to the connection cable on the
building side according to Figure 2. The
cables must be connected in a watertight
manner (e.g. with a cable sleeve).
4. Now place the luminaire in the
installation opening.
5. The installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Ground recessed light (LC-EL-026-WW) - Assembly instructions
Figure 1
Figure 2
10/2022