iRobot Roomba RMA-Y1 Guía De Seguridad página 5

Regulatory Information
FCC Supplier's Declaration of Conformity
iRobot Corporation
Contains FCC ID: UFE-AXEY1 and contains IC: 6652A-AXEY1
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: 1)
This device may not cause interference, and 2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
• Changes or modifications not expressly approved by iRobot
Corporation could void the user's authority to operate the
equipment.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules
as well as ICES-003 Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
to radio communication will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
Roomba Model: RMA-Y1
• Under Industry Canada regulations, this radio transmitter may only
• FCC Radiation Exposure Statement: This product complies with
• ISED Radiation Exposure Statement: This product complies with the
http://global.irobot.com
For battery recycling go to call2recycle.org;
or call 1-800-822-8837
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than the necessary for
successful communication.
FCC §2.1093(b) for portable RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as
described in this manual.
Canadian Standard RSS-102 for portable RF exposure limits, set
forth for an uncontrolled environment and is safe for the intended
operation as described in this manual.
Braava jet m6 Safety Information Guide
®
EN