Parkside PDSS 16 A1 Traduccion Del Manual De Instrucciones Originale página 35

■ Please ensure that you have read and understood
the safety instructions before fitting, operating,
repairing, servicing or replacing any accesso-
ries and before working near the compressed
air tool . Failure to do this can result in serious
bodily injury .
■ The compressed air tool should only be set up,
adjusted or used by adequately qualified and
trained operators .
■ The compressed air tool may not be modified .
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator .
■ Never use damaged compressed air tools .
Maintain compressed air tools with care . Check
regularly whether moving parts function correctly
and do not jam; check whether any parts are
broken or damaged to an extent that the com-
pressed air tool will no longer operate correctly .
Check signs and labels for completeness and
readability . If damaged, have parts repaired or
replaced before using the compressed air tool .
Many accidents are caused by poorly main-
tained compressed air tools .
Hazards caused by flying parts
■ If a workpiece or accessory of the compressed
air tool breaks, parts can be flung out at high
speeds .
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance of the
compressed air tool . The level of the required
protection must be evaluated separately for
each individual task .
■ You must ensure that the workpiece has been
securely fixed in place .
■ Check regularly that the rotation speed of
the compressed air tool is not higher than the
specified rotation speed appended on the
compressed air tool . These rotation speed tests
must be conducted without any accessory tools
attached .
■ Ensure that sparks and fragments created during
work do not constitute a hazard .
■ 32 │ GB │ MT
All manuals and user guides at all-guides.com
■ Separate the compressed air tool from the com-
pressed air supply before replacing the attach-
ment or accessories or before you adjust the
settings, service or clean the tool .
■ Ensure that no dangers are created for other
persons either .
Hazards caused by entanglement
■ Dress properly . Do not wear loose clothing or
jewellery . Keep hair, clothing and gloves away
from the compressed air tool and moving parts .
Loose clothes, jewellery or long hair can be
caught in moving parts . There is a risk of per-
sonal injury .
Hazards during operation
■ Avoid contact with the rotating shaft and the
accessory tool to prevent cuts on your hands
and other body parts .
■ When using the machine, the operator's hands
can be subject to hazards such as cuts, grazing
and heat . Wear suitable gloves to protect your
hands .
■ The operator and maintenance personnel must
be physically capable of handling the size,
weight and power of the compressed air tool .
■ Hold the compressed air tool correctly:
be ready to counteract any normal or sudden
movements – keep both hands ready .
■ Keep proper footing and balance at all times .
■ Prevent unintentional starting . If the air supply is
interrupted, switch off the compressed air tool
on the On/Off switch .
■ Use only the lubricants recommended by the
manufacturer .
■ Use personal protective equipment . Always
wear eye protection . Wearing personal pro-
tective equipment such as protective gloves,
non-slip safety shoes or hearing protection,
depending on the type and use of the power
tool reduces the risk of personal injuries and it is
recommended .
PDSS 16 A1