Parkside PDSS 16 A1 Traduccion Del Manual De Instrucciones Originale página 40

Refilling oil
To ensure that the tool remains operational for
a long time, the tool must have a sufficient fill of
pneumatic oil .
You have the following options:
♦ Attach a maintenance unit with an oiler to the
compressor .
♦ Install an add-on oiler in the compressed air line
or the compressed air tool .
♦ Add 3–5 drops of pneumatic oil into the con-
nector nipple after every 15 minutes of
operation .
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6,3 bar)
must be fully reached, and
–
make sure that the trigger is in the upper
position .
► Use only connection hoses with an internal
diameter of at least 9 mm .
► Use only filtered, lubricated and regulated
compressed air .
♦ Wrap the Teflon tape
nector nipple before you screw it into the
compressed air tool . Wrap the tape as tightly
as possible around the thread . This lowers the
probability that air will escape and it optimises
the work process .
♦ Screw the connector nipple
. Tighten the connection with a pair of pliers .
♦ Attach the tool to a compressor by connecting
the connector nipple
the compressed air source .
PDSS 16 A1
All manuals and user guides at all-guides.com
around the con-
into the air inlet
with the supply hose of
CAUTION!
► Ensure that the compressed air hose is
firmly attached . A loose hose can thrash
about uncontrollably causing grave danger .
Likewise, ensure the firm seat of the two screw
connections between the coupling piece and
the appliance .
♦ The compressed air source must be equipped
with a pressure reducer so that you can regulate
the air pressure .
Operation
Changing/inserting the tool/collet
chuck
CAUTION!
► The shaft diameter of the tool must exactly
match the clamp bore of the collet chuck
(Ø 6 .35 mm / 3 .2mm)!
♦ Hold the spindle
♦ Unscrew the collet chuck nut
using the assembly tool
♦ Insert the tool into the collet chuck
♦ Hold the spindle
♦ Tighten the collet chuck nut
tool .
■ Ensure the accessory tool is firmly attached .
CAUTION!
► If no tool is inserted into the collet chuck
, do not tighten the collet chuck nut
the assembly tool
only!
using the assembly tool
from the thread
.
/ .
using the assembly tool
using the assembly
with
, screw it on by hand
GB │ MT │ 37
/
.
.
/
■