Publicidad
Idiomas disponibles
Idiomas disponibles
4. PRODUCT DESCRIPTION
1.
Record plate
2.
Record disc shaft
3.
Record adapter
4.
USB REC socket
No playback. For recording only.
5.
Tone-arm
6.
Stop / Rec (USB record button)
7.
Tone-arm lever
Raise and lower the tone-arm.
8.
Aux In (3.5mm)
Connection of an external playback device.
9.
RPM. Speed setting switch (33/45/78)
10.
Function controller
BT (Bluetooth) / AUX IN / PHONO
5. USE
5.1
Before each use of the product
Note: During playback, the disc rotates at high speed.
DO NOT lift or move the device during playback. DO NOT
close the device during playback. Doing so may damage
the disc or the device.
1.
Carefully remove the device from the box and
remove all packaging material from the device.
2.
Place the device on a stable, level surface.
3.
Unwind the power cord.
4.
Connect the device to your home socket using the
included power supply.
5.
Open the lid of the turntable.
6.
Remove all transport locks (adhesive strips, etc.).
7.
Remove the white plastic cover from the clay needle
by pulling it in the direction of the arrow.
8.
Remove the cable tie from the tone-arm.
5.2
Power supply
Connect the power adapter to the device and your house socket. Note that the power source corresponds to the
values of the power supply. The device may only be connected to a DC 5V 1A power supply.
5.3
Switch the unit on/off
•
Turn the device on:
Turn the [Power controller] control to switch on the device. The power LED lights up when the device is switched on.
•
Turn the device off:
Turn the [Power controller] control to switch the device off. If the device is switched off, the power LED does
not light up.
5.4
Volume adjustment
To change the volume, turn the [Volume control] until the desired volume is reached.
5.5
Setting the function mode
1.
To select the desired function mode, turn the [Function controller].
2.
The selected mode is shown in colour by the Power LED.
3.
The following function modes are available: BT (blue) / AUX IN (purple) / PHONO (red).
5.6
Bluetooth mode
1.
Turn the [Function controller] knob to BT (Bluetooth) to select the Bluetooth function.
2.
The Power LED shows whether a device is connected.
•
No device connected: Power LED flashes blue.
•
Connected to the device: Power LED lights up blue.
3.
Start the Bluetooth search on your external playback device.
4.
Select Q.1867 from the Bluetooth list.
11.
Auto stop switch
Switches the auto stop function on/off.
12.
Power controller (volume)
Device on/off. Adjust volume.
13.
Power LED
Lights up when switched on.
Shows the function mode in colour.
14.
Aux out
15.
Tone needle
16.
Loudspeaker (Sound output)
17.
Handle for transportation
18.
Lock (Lock / unlock the case lid.)
19.
Line out (Cinch output.)
20.
DC input (DC 5V / 1A)
7 7
Tone-arm
Locking lever
Plastic cover
EN
Publicidad
