Publicidad
Idiomas disponibles
Idiomas disponibles
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing out your first grinding procedure and
after every disc replacement. Switch the
device off immediately if the grinding disc
is not rotating smoothly, if considerable
vibration occurs or if you hear abnormal
noises.
Practical tips
Always work with a low feed rate. Exercise
only moderate pressure on the material.
The device should not be loaded so
heavily that the cutting disc comes to
a standstill.
Hold thin materials, e.g. fabrics, under
tension and work slowly and with minimal
pressure.
This means that you will avoid catching the
material and having it jam the cutting disc.
Always wait until the cutting
disc (
still before removing material
caught in the device.
Always mark out cutting paths in advance,
in order to avoid unnecessary waste.
3) is fully at a stand-
Cutting line mark:
With the cutting line mark (2), you can
orient yourself to pre-marked cutting path-
ways, thereby allowing precise work with
the tool.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
GB MT
69
Publicidad
