Descargar Imprimir esta página

Parkside PMSA 12 A1 Traduccion Del Manual De Instrucciones Originales página 71

Ocultar thumbs Ver también para PMSA 12 A1:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Troubleshooting
Switch off the tool and remove the battery before you service the tool.
Problems
Device doesn't start
Cutting tool does
not move although
the engine is run-
ning
Engine is slower
and stops
Cutting disc does
not rotate smoothly,
abnormal noises
can be heard
Replacement parts / Accessories
Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 73). Please have the order number mentioned below ready.
Item. Description .............................................................Order-No.
9
Battery .............................................................................. 80001260
18
Charger EU ....................................................................... 80001326
3
Cutting disc ....................................................................... 91103070
We recommend that you only use the battery with the corresponding charger.
Possible Cause
Mains voltage missing
Main circuit breaker is tripped
On/off switch (
defective
Engine faulty
Clamping screw (12)
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Clamping screw (12)
Cutting disc is defective
www.grizzly-service.eu
Error correction
Check the socket, mains cable,
line, mains plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
5) may be
Repair by Customer Care
Tighten
is loose
„Changing disc")
Remove blockages
Reduce pressure on cutting tool
Workpiece unsuitable
Tighten
is loose
„Changing disc")
Change cutting disc
GB MT
clamping screw
(see
clamping screw (12)
(see
71

Publicidad

loading