TFA 30.3054 Instrucciones De Uso página 10

TFA_No. 30.3054_Anleit_03_23
Wireless Thermo-Hygrometer
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swal-
lowed, this can lead to serious internal burns and death within two hours. If you sus-
pect a battery could have been swallowed or otherwise caught in the body, seek medical
help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk
of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by
leaking.
• Never use a combination of old and new batteries together, nor batteries of different
types.
• Avoid contact with skin, eyes and mucous membranes when handling leaking batteries.
In case of contact, immediately rinse the affected areas with water and consult a doctor.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Protect it from moisture.
• The transmitter is protected against splash water, but is not watertight. Choose a shady
and dry position for the transmitter, when used outside.
5. Components
Base station (Receiver)
A: Display (Fig. 1):
Display 1, 2 and 3 for transmitter 1-3
A 1: Channel number with reception and battery symbol
A 2: Temperature
A 3: Temperature tendency indicator
A 4: Hi-/low-alarm for temperature
A 5: Comfort level symbol
A 6: Humidity
A 7: Hi-/Low-Alarm for humidity
A 8: Marking for selected channel
A 9: Symbol for MAX/MIN
Display IN for internal sensor and transmitter 4-8
A 10: Display for internal sensor and transmitter 4-8
18
06.03.2023 15:15 Uhr Seite 10
Wireless Thermo-Hygrometer
B: Buttons (Fig. 1):
B 1: MIN/MAX / – button
B 2: ALARM / SET button
B 3: CHANNEL / + button
C: Housing (Fig. 2):
C 1: Stand (fold out)
C 2: Battery compartment
D: Transmitter (Fig. 3):
Housing front:
D 1: Transmission signal lamp
Display:
D 2: Channel number
D 3: Temperature and humidity
Housing back side:
D 4: Wall mounting hole
D 5: Battery compartment
Inside the battery compartment:
D 6: Switch 1, 2, 3 and 4
6. Getting started
• Place the instruments on a desk with a distance of approximately 1.5 meter. Avoid get-
ting close to possible interference sources (electronic devices and radio installations).
6.1 Installation of the transmitters
1. Open the screwed battery compartment of the first transmitter.
2. Slide down for the first transmitter the first, the second and the third switch.
3. Slide up the fourth switch to select temperature display in °C (Celsius) or slide down to
select °F (Fahrenheit) as the temperature unit.
4. Insert two new batteries 1,5 V AAA. On the display appear the temperature and humidity
and the channel number 1.
5. Close the battery compartment again.
19