Stadler Form Albert Manual De Instrucciones página 7

Ocultar thumbs Ver también para Albert:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
• The dehumidifier must always be operated according to this instruction
manual. Non-observance of these instructions can lead to injuries, a fire,
electric shock or faults in the appliance.
• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• Do not use the dehumidifier if it is faulty or could show signs of damage,
or if it is not functioning correctly. Disconnect the plug from the power
socket.
• The appliance shall be installed in accordance with national wiring regu-
lations.
Setting up / operation
1. Place Albert on a flat surface in the desired area. Plug the power cable
(16) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). There are 3 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set. Press on
the knob hygrostat (4) and change to desired humidity level with the
rotary control (10). Humidity levels between 30 and 80 % or continu-
ous running (CO in display) can be selected. A humidity level not higher
than 60 % is suggested in general. If the dehumidifier reached the
selected humidity it will turn off and after that check the humidity
level in constant intervals by turning on the fan for a short time.
5. With the timer you can select precisely when Albert should be running.
The timer can be activated by pressing the knob timer on/off (6) and
the LED will be lit. If you press the knob again the timer will not be ac-
tive and the LED will be off. To set the timer follow these instructions:
6. Set the time: Press set (7) for 5 seconds and the symbol for hour is
shown blinking in the display, in addition the hours are blinking. Now
you can choose the correct hour with the rotary control (10). If the
hours are correct, press set (7) again and the minutes can be adjusted
the same way. To finish press set (7) again.
7. Set the timer: Press set (7) shortly and now you can set the time when
the unit should turn on (timer on) and the time when the unit should
stop (timer off), setting is the same as for the time above. If the timer
is activated (blue LED is on), the dehumidifier will start and stop every
day at the set time (this is ideal for example to use the cheaper power
tarifs at night).
8. The swing mode (8) allows to optimally distribute the dry air in the
room. This mode is also suitable for example to dry clothes fast and
efficient.
9. If you find the display and LED too bright (in a bedroom for example),
you may reduce the light intensity by pressing the night mode (9).
10. Once the water tank is full, the blinking symbol will appear on the
display and the dehumidifier turns off automatically. Please empty the
tank. Once you put back the tank, the unit will automatically restart.
11. Defrost function: If the temperature in the room is below 5 °C, the
dehumidifier automatically runs in defrost mode. This mode is shown
on the display and frost build up in the unit will be avoided during
dehumidification. This function will be activated every 25 minutes for
a duration of 7 minutes.
12. If desired, it is possible to connect a drainage hose to the unit for per-
manent water drainage. In this case connect the hose (2 m) (17) to the
unit through the hole in the back of the dehumidifier and place the
end of the drainage in a water outlet. Please make sure the end of the
hose is lower than the spout, otherwise the water will not drain and
flooding may occur.
13. For easy side movement of the unit there are hidden wheels (18) at-
tached. Empty the tank first before moving the dehumidifier.
Cleaning
Before servicing the appliance and after each occasion of use, switch off the
appliance and unplug the mains cable from the socket.
• Attention: Never immerse the appliance in water (danger of short-circuit).
• To clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
• In case the filter (13) at the air inlet (12) is dirty or dusty, take the filter out
and remove the dirt/dust with a vacuum cleaner.
• If you don't use the dehumidifier for some time, empty the water tank and
dry the unit fully before storing it in its original carton.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.
Disposal
The European directive 2012 / 19 / CE on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must
not be disposed in the normal unsorted municipal waste stream. Old appli-
ances must be collected separately in order to optimize the recovery and
recycling of the materials they contain and reduce the impact on human
health and the environment. The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when you dispose of
the appliance it must be separately collected. Consumers should
contact their local authority or retailer for information concerning
the correct disposal of their old appliance.

Publicidad

Tabla de contenido
loading

Tabla de contenido