28. HEADPHONE JACK
Connect a headphone fitted with a ¼" jack
29. POWER SWITCH
Press this button to turn on the unit once all input devices have been connected to prevent damage to
your equipment. Turn the mixer on before you turn on the amplifier and turn off the amplifiers before you
turn off the mixer.
REAR PANEL
30. POWER SUPPLY INPUT SOCKET: Connect the mains lead to it.
31. BALANCED OUTPUT CONNECTOR: Connect the mixer to an amplifier via the balanced connector.
32. ZONE OUTPUT: Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth or in
a remote location.
33. MASTER OUTPUT: Connect the mixer to an amplifier using cables fitted with ¼" plugs.
34. EFFECT INPUT: Connect a sound effect device such as a reverb, sampler, etc. and play the signal from it.
35. EFFECT OUTPUT: Connect a sound effect device such as a reverb, samples etc. and play another input
through it.
36. LINE INPUT: Allows you to connect most high-level audio sources such as CD players, tape decks, tuners or
VCR's.
37. INPUT SELECTOR: Set these switches based on what is plugged into the PHONO/LINE input jacks.
38. MICROPONE JACK INPUT: Connect a microphone fitted with a ¼" jack to it.
39. GROUND: Ground screw for turntables.
BLUETOOTH OPERATION
Press the MODE button (A) to select Bluetooth mode. The mixer will enable the connection to a Bluetooth sys-
tem. Start the Bluetooth search on your device and select BT in the list of found devices. Now, your device and
the mixer are linked. Set the input selector switch of channel 4 to BT operation. The sound of your Bluetooth
device is fed through channel 4. Start playback on your device to hear the sound in the mixer.
SPECIFICATIONS
Inputs:
Phono: ......................................................................................................................................................... 3mV, 47kOhm
Line ........................................................................................................................................................... 50mV, 27kOhm
MIC 1, 2, 3 ......................................................................................................................................2mV, 2kOhm balanced
Bass .....................................................................................................................................................................+/- 12dB
Treble ...................................................................................................................................................................+/- 12dB
Outputs:
Amp ........................................................................................................................................................................0dB 1V
Max. ......................................................................................................................................................... 8V Peak-to-peak
Rec ............................................................................................................................................................ 120mV, 5kOhm
Zone........................................................................................................................................................................0dB 1V
General:
Frequency response ..........................................................................................................................20Hz – 20kHz +/-2dB
S/N ratio ..................................................................................................................................................Better than 80dB
Talkover attenuation .................................................................................................................................................-16dB
Headphone impedance .......................................................................................................................................... 16Ohm
Max. RF transmission value .................................................................................................................................2.65dBm
Power supply .......................................................................................................................................220-240V~50/60Hz
Dimensions .......................................................................................................................................... 481 x 86 x 240mm
Weight ....................................................................................................................................................................... 3.4kg
Correct disposal of the product
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
MANUAL - DJM102-BT
www.ibiza-light.com
5