Publicidad
Idiomas disponibles
Idiomas disponibles
8.
Don't touch the electrode/rod holder right after welding because they may be hot.
9.
Use the manual together with the equipment, read it carefully and follow the instructions. Use the
equipment only according to its specifi c purpose and observing the instructions of this manual.
Improper operation may cause risks to people, animals and property. The users of the welding
equipment are responsible for their own and the other's safety. Therefore, understand and follow
the safety instructions:
10.
Make sure the power trigger is in the "off" position before connecting the tool to the power grid.
11.
The equipment model must be chosen in compliance with the established use. Do not force your
equipment excessively. If required, acquire a more suitable equipment for the application. This will
increase the effi ciency and safety in the work;
12.
Fastening of the part: to avoid accidents, always fasten the part properly before
starting drilling, especially small parts. If required, use clamps.
13.
Use your equipment only for the purpose it was designed, according to the intended use described
in this manual. Do not use it for other purposes;
14.
Do not expose your power equipment to rain or wet conditions. Contact with water will increase
the risk of electrical shock;
15.
Avoid touching the torch tip right after cutting, as the torch can be hot.
16.
Use the manual together with the equipment, read it carefully and follow the instructions. Use the
equipment only according to its specifi c purpose and observing the instructions of this manual.
Improper operation may cause risks to people, animals and property. The users of the welding
equipment are responsible for their own and the other's safety. Therefore, understand and follow
the safety instructions:
About the work place and conditions:
• Repairs and/or maintenance can only be executed by qualifi ed personnel;
• Always disconnect the equipment from the power supply before performing any service;
• Only use welding cables supplied with the equipment;
• Do not modify the equipment and do not operate it with missing, adapted or non-genuine parts;
• Provide the equipment with proper maintenance. Keep the machine in safe operating
conditions, replacing damaged insulations;
• The equipment must be placed in a fl at and stable surface. Due to vibrations, it may fall if placed on
a high surface;
• During operation, the equipment must be kept in an open place, so that the air can fl ow through the
side slots;
• The cutting/welding process generates harmful gases and smokes; therefore, make sure there is
enough ventilation at the work place;
• Make sure the equipment is properly connected to the power supply and do not bend or twist the
power cables ;
• Pay attention to the conditions of the ground cable and torch cable. In case of insulation breaking or
oxidation, change the cables immediately;
30
Publicidad
