TOPDON BTMOBILE PROS Manual Del Usuario página 5

Idiomas disponibles

APP Installation & Setup

Installation:

Please scan the QR code or visit our offical website:

https://www.topdon.com/products/btmobile-pros to

download and install the APP.

NOTE: Compatible with Android 4.4 smart devices,

or newer.

Set up

For the first time, you

can choose to register

with email or skip

recommend the

registration for latest

product news and timely

technical assistance.

Operation Introduction

Before Test:

1.Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all of the

vehicle's doors and trunk lid.

2.Make sure the battery terminals are clean. Use a wire brush to clean them, if necessary.

NOTE: This tester works best if the battery connectors have been removed and the battery posts have

been cleaned. Any corrosion between the tester clamps and the battery connectors, or between the

battery connectors and the battery posts, will degrade the tester's efficiency.

3.Connect the RED (+) Positive Battery Clamp to the (+) positive battery terminal, and connect the BLACK

(-) Negative Battery Clamp to the (-) negative battery terminal. Ensure that the clamps are securely

attached to the correct terminals.

4.Open the Bluetooth on mobile device or tablet.

5.Test Introduction

• BATTERY TEST: Display SOH (State of Health), SOC (State of Charge), Voltage, Test Value, Internal

Resistance, and the readable analysis results on App;

• CRANKING TEST: Analyze the actual cranking voltage and the cranking time to help you quickly figure

out the whole state of the starting system;

• CHARGING TEST: Test different parts of charging system, including generator, rectifier, rectifier diode,

and so on for a reliable charging volt value.